Responsible in SMT paste printing and glue process to develop, optimize processes for new product introduction/ development and sustaining product engineering activities based on proper studies (e.g. Design of Experiment, risk assessment, equipment & process capability).
Generate and maintain the standardized work documents.
Ensure that the respective area workstation and system are well maintained in operation condition.
Define equipment preventive maintenance plan in close collaboration with maintenance team. Provide training on machine maintenance, operation and processes when necessary.
To assist in major machine breakdown troubleshooting.
To participate in new product development discussion and contributes ideas and comments for PCB assembly and process technology.
To participate, setup and review traceability for respective area and improve timely.
To be the Data Owner of the processes under care and set-up of a proper Data Management for Data Visualization and Analytics.
Responsible for process & yield improvement, cost reduction and cycle time reduction. Apply statistical method, systematically problem-solving tools (e.g. fault tree analysis, 3x5xwhy, DOE, 6- Sigma, Kepner Tregoe) or management tool (e.g. System CIP) to get desired results.
To work closely with CoC (Centre of Competence) team to comply, standardize and improve processes via PFMEA and VVts/DMDs.
Conduct equipment capability studies and evaluate processes. If needed, prepare ROI analysis and arrange supporting purchases.
To achieve the department goal through continuous process improvement activities.
Provide support in process and line audits, technical advice request from project team.
Product engineer for the model assigned
Any other assigned by immediate supervisor from time to time.